Plants such as Streptocarpus, Sansevieria, Eucomis, Sinningia (syn. Gloxinia), Begonia masoniana and B. rex hybrids can be propagated from part-leaf cuttings.

Taking whole leaf

A method of growing new plants from parts of an existing plant, such as sections of root, stem, leaf or bud. When prepared correctly and planted in the right conditions, they can produce roots and eventually become independent plants. There is a wide range of different methods for taking cuttings, depending on the plant and time of year.

Succulents such as Kalanchoe, Echeveria, and Crassula (for example Crassula ovata – the jade plant) are very successful when propagated by leaf cuttings.

Tender sedums (e.g. Sedum rubrum, Sedum hintonii, Sedum morganianum) as well as the hardy herbaceous

Perennials are plants that live for multiple years. They come in all shapes and sizes and fill our gardens with colourful flowers and ornamental foliage. Many are hardy and can survive outdoors all year round, while less hardy types need protection over winter. The term herbaceous perennial is used to describe long-lived plants without a permanent woody structure (they die back to ground level each autumn), distinguishing them from trees, shrubs and sub-shrubs.

Always select healthy, young, fully grown foliage. Avoid any damaged, diseased material or leaves affected by pests. Use pot or trays filled with free draining compost such as seed and cutting compost or mix equal quantities of multipurpose compost and sharp sand or perlite.

Part-leaf cuttings

Streptocarpus: Select a full-grown leaf and cut in half along the midrib, which should be discarded. Using a seed tray make a shallow trench and insert the leaf, cut side down and firm in.

Sansevieria, Eucomis: Cut leaves horizontally into 5cm (2in) pieces and insert lower edge down. Make sure to keep the cuttings facing the direction that it was growing on the plant, alternatively cut into shallow chevrons. Insert the cuttings vertically about 2cm (3/4in) deep.

 Begonia, Sinningia: Cut across the main veins on the underside. Pin the leaf, cut side down onto the compost. Alternatively, cut the leaf into squares 2.5cm (1in) across each with a main vein. Pin the squares to the surface of the compost.

Aftercare

• Water and allow to drain. Place in a propagator or a clear plastic bag in a light place out of direct sunlight. Leaf cuttings from tropical plants must be kept in high humidity at about 20°C (68°F).
• When plantlets form, remove covers and allow them to grow on until large enough to pot up individually.

Whole-leaf cuttings

Sinningia (syn. Gloxinia), Streptocarpus (African violet, syn. Saintpaulia), Peperomia: Cut the leaves with the stalk intact from the parent plant. Using pots, insert with the base of each leaf just touching the surface and treat as for part-leaf cuttings.

Kalanchoe, Echeveria, Crassula: Leaf cuttings of succulents should be left a day or two to callus (the cut surface thickens) before potting. Insert into pots filled to three-quarters depth with two parts cactus compost to one part fine grit, topped off with fine grit. Do not cover. Place in warm position and good light. Keep the compost just slightly moist.

The cutting will be prone to rotting off if the compost is too wet. Water carefully and air the cuttings about twice a week and remove any decaying leaves promptly. This will help reduce problems with grey mould.

The development of the plantlets will slow at low temperatures. Keep the cuttings at about 20°C (68°F).

Poor growth can be caused by low light levels. Place in a well lit place but protect from direct sunshine.

Watch out for pests such as aphids, whitefly and mealybug.